NSQ Mechanical LTD.

NSQ Mechanical LTD. Bringing piece of mind to our customers, knowing that we “Never Sacrifice Quality”. No project t

10/20/2022
Who thinks we should start handing out these custom branded  products to customers after completed jobs to show our appr...
10/02/2022

Who thinks we should start handing out these custom branded products to customers after completed jobs to show our appreciation for the opportunity of working for them? Everyone loves a !

On a job and you need some extra hands at short notice to bang out a big push? No problem, we got you! A clean shot of t...
09/23/2022

On a job and you need some extra hands at short notice to bang out a big push? No problem, we got you! A clean shot of the Milwaukee Tool] packouts before tools were slung and pipe was hung on this industrial job our friends called us into for some last minute help. Of course at NSQ we trust none other than Milwaukee Tool] to tote all the necessary tools we need to show up and perform!

02/16/2022
02/16/2022
Underground hangers anyone? Sometimes the specs of the job require you to go above and beyond. Never mind the hangers.. ...
02/05/2022

Underground hangers anyone? Sometimes the specs of the job require you to go above and beyond. Never mind the hangers.. The inspector joked he almost had to fail us for the install looking “too good”. Here at NSQ we believe no matter if it’s under dirt, covered in insulation or behind a wall no one will see for years that the quality of the work does not change! The pictures of this commercial Reno show we mean it! Give us a call today to get your top notch project started!

 showing that even trap primer lines to be covered in drywall can be a work of art! A clean install on one of our commer...
02/05/2022

showing that even trap primer lines to be covered in drywall can be a work of art! A clean install on one of our commercial projects. Great job Matt!

Heating pre fab today made easy by Milwaukee Tool]. Could you imagine how much time you would spend cutting 124 pieces o...
02/05/2022

Heating pre fab today made easy by Milwaukee Tool]. Could you imagine how much time you would spend cutting 124 pieces of 3/4” copper by hand? I would say with this it’s less than 10 seconds per cut. Started with 3 bars of battery on a 3amp m12 and it didn’t even move down one bar! Milwaukee Tool] killing it with trade specific tools/tools in general. Can’t wait to see what they make for plumbers next!

A little peek of some finishes recently installed on one of our new build custom home projects just outside of town. Did...
11/29/2021

A little peek of some finishes recently installed on one of our new build custom home projects just outside of town. Did you know we not only service Calgary but all surrounding areas. Planning a new build? Give us a call!

10/03/2021

Quite a lengthy gas line install we did today on one of our custom home projects. Threaded, welded, soldered, crimped or glued. No job is too big or small, give us a call!

Address

Calgary, AB

Telephone

+14034020195

Website

Alerts

Be the first to know and let us send you an email when NSQ Mechanical LTD. posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Featured

Share