09/23/2026
The chilly nights & early mornings the past several days definitely reminded us that Fall (Autumn) was just around the bend, & as of last night, it has officially arrived. A lot of us tend to be defiant when it comes to turning our heat on before a certain time (us too), but we'd like to let you know that now is a good time to do a test run on your system to make sure it fires up fine & there are no concerns before the real cold temps hit. Earlier in the morning or later in the day when the temperature drops again, turn your system on, turn the thermostat up, & make sure everything is cycling & your baseboard, panels, radiant, etc. are getting warm. Your baseboard & piping may be cold so some creaking or "snapping" heard will usually be normal, but should subside once the system fully cycles through & everything gets warm. If something seems off, it doesn't hurt to reach out. Our most common "no heat" calls tend to be: dead thermostat batteries, or out of fuel. We recommend checking &/or replacing your thermostat batteries at the start of every season, & check your oil/LP tanks regularly. In Addition, we are a small business that primarily focuses on repair & maintenance, & no heats during the heating season always take priority. At this time, we are not taking new estimate appointments for full system replacements or larger jobs until this heating season is over, unless it is an emergency. We will start taking new estimates for larger jobs again beginning April 1, 2027.