Electech Installation's

03/06/2026

One of Electech Installation's jobs this week was the installation of 8 x double sockets at a property in Eglinton

Our apprentice chased out the walls using a metabo wall chaser and vacuum to minimise the dust, whilst i wired the sockets.

Some areas of the chased wall was filled and bonded to secure the cables for safety reasons, following next day for plaster patch.

All works was tested and an electrical safety certificate was issued.

25/05/2026

22/05/2026

Another job this week was a safety compliance inspection and certificate in Alkimos for Ray White Property agents.

We completed RCD Testing, earth tests, visual inspections and testing the smoke detectors.

22/05/2026

Another job this week we wired and installed extra doubles sockets and an outside light with a light switch to a property in Yanchep.

22/05/2026

One of Electech Installation's jobs this week involved wiring and installing a new 3 phase supply for a Tesla EV charger, the cabling was enclosed in ducting at the isolator and switchboard and wired through the roof space, and our apprentice fitted off the isolation and was shown how to inspect and carry out dead testing of the circuit.

We also wired an outdoor camera with built in lights to the front of the property.

07/05/2026

A busy week so far for Electech Installation's.

We installed an LED strip light to the front of a property in Eglinton which was wired to an independent switch in the hallway... How amazing does that look... 🤩

Please call Curtiss for a free no obligation quotation. 😎

07/05/2026

Our apprentice hard at work fitting off sockets and outdoor lighting at a property in swan view. 😎

07/05/2026

This week we was at Bar 1 nightclub in Hillarys which is undergoing a major refurbishment to the club.

Electech Installation's carried out alterations and additions to power, LED lighting and emergency lighting, and rectified a fault to the sockets on the stage area

Looking forward to seeing this complete in 2 weeks time.

07/05/2026

Today we carried out maintenance work at a shop in Currambine called Aurora Skin and Body.

There were several lights not working to the front reception area and middle and rear of the shop therefore we replaced the LED Drivers and also repaired some LED ceiling panel lights and found a loose connection to the driver. All lights to the shop were restored. 😎

We return in a week's time to test and tag appropriately 40 electrical items.

22/04/2026

Another job this week for Electech Installation's was a job in Canningvale, and work consisted of 2 new supply's for a swimming pool heater and a pool pumps.

1 x 20 Amp circuit was wired for the pool heater and 1 x 16amp supply for pools pumps, both fitted with new RCBO's

We also wired outside lighting to illuminate the pool. 😎