Severn Plumbing & Wood Burning Stoves

02/03/2026

Callled out today to repair a pipe that had blown off on the main incoming mains, changed the olive to a copper olive so should be a stronger joint now

02/03/2026

Installed this lovely Contura 690T Style burner this week together with a twin wall flue system, this was replacing and old wood burner that was in the same position.

23/02/2026

Replaced this failed mixer valve on a biomass boiler system today a little tricky as no drain off on the pipe work that I wanted to work on

18/02/2026

Finished installing this 8kw Hunter Herald multifuel stove onto an existing flexible flue liner, the wooden beam was fire protected and a new steel register plate was fabricated and installed.

18/02/2026

Fitted this 5kw Dunsley Highlander in a newly constructed conservatory, this was an afterthought so was a little awkward, the builder will make good the ceiling and a double heat shield is being fabricated for behind the stove,
I will be returning to commission the stove once works are completed

13/02/2026

Replacement mixer tap fitted along with new isolation valves

13/02/2026

Went to this job to fix a leak , worn flexible tap connectors replace , new tap washers,
Then bleed the oil system on a old Worcester boiler to get it back up and running ,
Drill through the kitchen worktop and fitted push button for the waste disposal unit,
Drilled a couple of new kitchen drawers and fitted new brass k***s.
All in the same house.

08/02/2026

Job from last week , removed the old stove and flexible flue liner.
The new 5kw Ecosy Purefire Curve was installed along with a 904 grade flexible liner, new steel register plate and a bird proof cowl was also fitted.

08/02/2026

Finished installing this 5kw Mazona Warwick multifuel stove, builder had removed the old fireplace and used wooden battens and thin fire board to line the chimney , the chimney was also fully blocked with a birds nest, unfortunately this was not up to regs and the battens and nest had to be removed, the loose stone wall was rough rendered with cement mix and a new slate hearth installed , now fully up to standard and safe to use.

29/01/2026

14/01/2026

Leaking immersion heater removed and capped of as will never be used as 3 other sources of heat input,