Jubilee Electrical Service Corp.

07/03/2019

Two more examples on how to NOT do this.

04/09/2019

The end result of something so simple as cutting too deep into the insulation when stipping the wire.

04/30/2018

Take a close look at the wire. Notice there are little copper beads coming through the insulation. Once again improper circuit protection allowed wire inside a pipe to overheat to point where the wire began to melt like little beads.

12/19/2017

Several issues here. 1-This circuit was not properly protected with a 20 amp breaker instead of a 15 amp that the wire was rated for use. 2-Even though this much damage occured it was very well controlled because the proper metal box was used and all connectors and openings were secure and in place.
This could have had a very different outcome if just one part of the system did not perform properly.

08/28/2017

Minimum seven years of experience in light, heat and power. Clean drivers license. Good communication skills. Send resume to email listed.

08/28/2017

07/25/2017

This is an example of how not to wire up an apartment.

07/25/2017

Before and after replacement of broken disconnect switch in elevator motor room

03/24/2017

Snow storm February 2015

03/24/2017

Electric Meter from 1911