Dyer's Plumbing Service

10/08/2025

Order this... If you drink a lotta water and I'll figure out the best way to run a water line to it. The hot side dispenses water at 175 degrees. Message me to set up a date/time for quote/installation.

Dyer's Plumbing Service
210 322 3484
RMP 43849

02/17/2024

My favorite part of plumbing is problem solving. There is nothing more satisfying than completing a challenging project.

02/05/2024

I tried to auger a sewer main and I just couldn't get the blockage to clear. Fired up this bad boy and got it cleared within minutes. Message me for pricing.

02/05/2024

Your kitchen sink won't drain? Tired of augering it? Say no more... This bad boy will get it cleared! Message me for pricing.

Here is a true story... A washing machine drain line was backing up. I arrived on site and noticed the old school plumbing. It was cast iron and the p-trap was beneath the slab. I noticed a vent on the roof... I took the jetter to the roof and ran it down the vent. I was able to get the drain line cleared without cutting the walls open to access the vent.

02/05/2024

High water bill? Can't find the source? This gadget will find leaks beneath concrete, asphalt, and soil. It takes a lot of time to cut sheetrock and find manifolds to test each fixture individually. It also costs a lot to have a house completely re-piped in the attic. Chipping concrete really isn't all that bad. Send those leaks my way and let's see if this thing works! I had a couple people ask me if I could detect slab leaks.... so, I broke down and bought this. Message me for pricing.

07/28/2023

07/27/2023

Fun fact: A bathroom sink wasn't draining at all. I stuck the air snake in the drain and pulled the trigger. Well... The pressure created a hole in the bottom of a chrome plated 1 1/4" p-trap. Off to the plumbing supply house I went. Good times.

07/26/2023

Dear diary... Monday was a blast! I could not think of any other place I would rather be. 130° in a attic... No problemo. Clothes that were fully soaked with sweat... No biggie.

Anyways... The front of this heater was not easily accessible. The T&P piping had a shark bite coupling. Sharkbite fittings are not approved for use on a temperature and pressure relief line. The old gate valve for the cold water shut off no longer functioned (easily).

Water heater in the attic? Smh... Who came up with this idea? Anyhow... I was there to replace the old heater and got er done. I purchased a new tool for the trim and left the place clean (as it was before I arrived).

PLUMB ON! 🍻 💪

07/26/2023

Dear diary... Yesterday was the absolute best day of my life (sarcasm). It was hot! Camera and locator found the troubled spot. I dug it up and got er done. It was three and a half feet deep. 😳 Approximately 80-90 feet away from the existing clean out.... So I added two additional clean outs for future service.

PLUMB ON! 🍻 💪