Christian Sith

Christian Sith Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Christian Sith, Plumbing service, New York, NY.

The equipment ate a mouse, all I had to do was reset the breaker and dispose of the mouse.
07/09/2026

The equipment ate a mouse, all I had to do was reset the breaker and dispose of the mouse.

Will using R-410A to boost the charge on an R-454B system function correctly?
07/08/2026

Will using R-410A to boost the charge on an R-454B system function correctly?

Is it possible that the ducting or exchange is responsible for the inadequate cooling performance?
07/05/2026

Is it possible that the ducting or exchange is responsible for the inadequate cooling performance?

The practice of burying a 210L unvented cylinder 2/3rds below the floorboard raises several questions regarding its effi...
07/05/2026

The practice of burying a 210L unvented cylinder 2/3rds below the floorboard raises several questions regarding its efficacy and purpose.

Contrary to YouTube videos, I experienced a significant setback today, validating Fowler's assertion.
07/04/2026

Contrary to YouTube videos, I experienced a significant setback today, validating Fowler's assertion.

Rate may curves
07/03/2026

Rate may curves

In my older renovated home, I installed a new kitchen faucet without incident initially. However, a few hours later, I n...
07/03/2026

In my older renovated home, I installed a new kitchen faucet without incident initially. However, a few hours later, I noticed a considerable reduction in water pressure. What potential causes should I investigate given that the valves for both hot and cold water are turned to their maximum capacity?

The fuse in the air handler blew at 3 am. I changed it, but the thermostat is still malfunctioning. I am looking into th...
07/02/2026

The fuse in the air handler blew at 3 am. I changed it, but the thermostat is still malfunctioning. I am looking into this further.

I am constructing a large deck at the rear of my residence and have concerns regarding the beam connection. Upon inspect...
07/01/2026

I am constructing a large deck at the rear of my residence and have concerns regarding the beam connection. Upon inspection, I noticed a gap at the bottom and an overcut, which appears to be a potential issue. The framing was completed today. Should the beam not bear down on the post with fasteners providing clamp force? Will this configuration settle with weight over time? There are approximately 14 posts, with half already bolted and roughly half exhibiting similar joints. What risks are associated with this construction? How should I address these concerns with my contractor?

Hi Mark, this is a welcome break on an otherwise slow day at the office, given my week-long installation project.
07/01/2026

Hi Mark, this is a welcome break on an otherwise slow day at the office, given my week-long installation project.

Address

New York, NY

Website

Alerts

Be the first to know and let us send you an email when Christian Sith posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category