Lamas Construction Co.

10/22/2023

Thanks for your likes.

09/25/2023

Very important to support the roof and the ceiling before removing the beam Removing a flush beam to install a larger one to extend the opening.

07/29/2023

03/25/2023

Another waterproofing deck job; done——////—-Otro balcón sellado a prueba de agua; ya terminado. 👍

03/25/2023

Applying the pigmented sealer chosen by the client—////—-Aplicando el sellador con pintura al gusto del cliente.

03/25/2023

The top coat is sprayed over the dried resin with a hopper. The polymer special cement is white with finer sand than the grey cement used on the base coat applied over the metal lath.——////—- La capa final es esprayada con un hopper. El cemento con polymer es blanco con arena mas fina que el cemento gris que se usa para la capa de base que va sobre la malla de diamante.

03/23/2023

Applying the resin over the fiberglass mat——///—-Aplicando la resina sobre la tela de fibra de vidrio.

03/20/2023

Applying stucco texture on the wall patch to match existing.——////—-Aplicando stucco con textura en el parche de la pared similar al existente.

03/15/2023

The metal weepscreed was installed using roofing nails, then installed the flashing paper. After that, installed the metal lath using wood galvanized Tek Screws, and last, applied the plaster using Rapid Set Stucco Mix.——////—-Se clavo el weepscreed con clavos para techo, luego se le engrapo el flashing paper. Después se atornilló la malla galvanizada usando tornillos Tek galvanizados para madera. Al final se aplicó el emplaste usando Stucco Mix marca Rapid Set.

03/12/2023

Welding the guard railing——/////—-Soldando el barandal

02/23/2023

Guard rail bolted down with lags embedded with polyurethane caulking. 2X6 bonderized “L” metal wall to deck flashing and bonderized dripedge.
Galvanized metal lath attached with 7/8” galvanized staples at 2” on center each way.
Also, application of the base coat of the water proof system by www.plidek.com.———-/////——- El barandal se instaló con tornillos galvanizados embutidos con caulking poliuretano. Se instaló el metal botaguas banderizado en la pared y el metal orillero. Se instaló la malla de metal galvanizada con grapas galvanizadas de 7/8” a 2” .
También se aplicó la base del revestimiento del sistema de www.plidek.com.